Browse through ODU ...

Customized configuration of your mass interconnect interface

Flexible use of the ODU-MAC® modules

YOUR BENEFITS

Easy handling: tool-free clip-in assembly and removal of the modules in the frame

Easy mounting and removal of contacts
Constantly low contact resistance
Customized combination of the different modules
High packing density
Modules including cable assembly

Signal – 20 contacts

Signal – 10 contacts

Signal – 6 contacts

Signal – 5 contacts

Signal – 192 contacts

Signal – 384 contacts

PCB termination modules – 20 contacts

PCB termination modules – 10 contacts

PCB termination modules – 6 contacts

PCB termination modules – 5 contacts

PE module – 1 contact

High‐voltage – 2 contacts

High-voltage – 6 contacts

High-current – 3 contacts

High‐current – 2 contacts for turned contacts with ODU LAMTAC®

Contact-∅: 5 mm

High‐current – 2 contacts for turned contacts with ODU LAMTAC®

Contact-∅: 8 mm

High‐current – 1 contact for turned contacts with ODU LAMTAC®

Coax – 4 contacts for 50 Ω coax contacts

Coax – 2 contacts for 50 Ω coax contacts

Coax – 2 contacts for 50 Ω coax contacts - SMA termination

Coax – 2 contacts for 75 Ω coax contacts

Compressed air / fluid / vacuum coupling – 2 contacts

Compressed air / fluid / vacuum coupling – 2 contacts

Compressed air / fluid / vacuum coupling – 2 contacts

Compressed air / fluid / vacuum coupling – 1 contact

Shielded feedthrough / high‐speed connector – 2 to 14 contacts for 2 insert size 1

Shielded feedthrough / high‐speed connector – 2 to 14 contacts for 1 insert size 1

Shielded feedthrough / high‐speed connector – 3 to 22 contacts for 1 insert size 2

Shielded feedthrough / high‐speed connector – 1 contact

Combination module – 2 contacts (High‐speed & coax)

Combination module – 2 contacts (High‐speed & compressed air)

Fiber optic – 4 contacts for fiber optic only pre‐assembled (Physical Contact)

Fiber optic – 4 contacts for fiber optic only pre‐assembled (Expanded Beam)

Fiber optic – 5 contacts for fiber optic also pre-assembled (POF)

Thermomodule – 6 contacts

Blank modules – Used to fill incomplete frames

ODU-MAC® Black-Line Configurator

Use this configurator to request new modules for your existing ODU-MAC® interface.

Configurator

¹ According to IEC 61010-1:2010 (VDE 0411-1:2020-03), supply voltage from grid supply circuit (Cat.2).

² Determined according to IEC 60512-5-2:2002 (DIN EN 60512-5-2:2003-01) at increased temperature 45 K.

³ The contact arrangement of an ODU data transmission connector differs from a standard data transmission connector due to the robust ODU specific design. However, the ODU design meets the electrical specifications of the respective standard data transmission protocol.

⁴ Single Pair Ethernet according to IEC 63171-6:2020 (IEEE 802.3bp).